Description
Review this item in the context of the repair, installation access, nearby parts, and the result the completed job is intended to achieve.
Oil Pressure Safety Switch1/8″ NPTShuts off when under 5 psi
No structured vehicle fitment data is available. Compare the listing with the vehicle and existing part before ordering.
Repair scenarios, installation, companion parts, and use outcomes
Buying guidance
Quick decision
Review this oil pressure in the context of the repair and the surrounding components.
Repair scenario
- Identify the symptom and confirm that this is the component required by the repair.
- Inspect nearby connectors, fasteners, and mating surfaces before installation.
Installation notes
- Use the listing instructions when present and follow the vehicle service procedure.
- Professional installation may be appropriate when the repair requires special tools or calibration.
Companion parts
- Inspect nearby fasteners, connectors, seals, fluids, and wear items before starting the repair.
- Use the service procedure and the visible package contents to identify any additional parts or tools required.
Before you buy
- Compare the listing title, photos, package contents, and specifications with the part being replaced.
- Confirm vehicle compatibility and installation requirements before ordering.
Customer feedback
Ratings and written reviews
4.8 / 5
32 source ratings
Source: Amazon. Imported marketplace feedback is shown for product research and is not a review of a purchase made on this website.
lee lopes –
Works first time, and every time!
xylmoom –
Cant say if it works well or not. It would need an adapter to work on a sbc with a performer manifold. It hits the manifold and wont allow it to tighten properly. Whit an HEI distributor being as large as they are the 2″ adapater jegs offers seems like it would hit the distributor , not sure, not trying. The screws to tighten would be a pain, getting a screwdriver in there to tighten them would be difficult, not impossible with an L shaped screw driver. Easier way would be to attach 3 , 6 inch wires to switch then attach those wirers to your harness using spade clips.If the screw in to the block part of the switch were say just 1 inch longer it would have worked perfect. As it is I had to order a different switch. My bad for not seeing the issue ahead of time, bad planning on my part.
Kylie’s Nana –
This part was ordered as a replacement part for our generator. The price was good, although the shipping cost as much or more than the part.
Fred Wunsch –
It was perfect
Ty Chamberlain –
Works as it should for a good price
whiteheat –
used this as a control circuit for an electric fuel pump install. did the job and easy to install. I actually installed two pressure switches, one for the actual gauge and the other for the control circuit.
Gordon Jones –
Good
BethAnn –
Used this switch on my Ford 3930 tractor and have had no issues.