Description
Review this item in the context of the repair, installation access, nearby parts, and the result the completed job is intended to achieve.
If you need custom bushings and reamer, please leave us a message, you provide the drawings, I provide the products, and the cooperation is happy!
The carburetor model for this kit:
GM TBIs
Carter Thermoquads
Holley 4-barrels (including muscle car carbs)
Ford (Autolite) carburetors and more
How to use the kit:
1 Remove the throttle shaft, clean the carburetor damper blades and throttle shaft
2 Using a hand-held variable speed drill (recommended bit size is 10.5mm, smaller than the actual aluminum hole 0.1mm), drill the aluminum hole of the carburetor throttle shaft
3 Reaming operation using the 7/16″ reamer included in the kit
4 Insert the front of the brass bushing into the aluminum hole
5 then pass the throttle shaft through the brass bushing
The role of the reamer: improve the accuracy and coaxiality of the aluminum hole
No structured vehicle fitment data is available. Compare the listing with the vehicle and existing part before ordering.
Repair scenarios, installation, companion parts, and use outcomes
Buying guidance
Quick decision
Review this rebuild kits in the context of the repair and the surrounding components.
Repair scenario
- Identify the symptom and confirm that this is the component required by the repair.
- Inspect nearby connectors, fasteners, and mating surfaces before installation.
Installation notes
- Use the listing instructions when present and follow the vehicle service procedure.
- Professional installation may be appropriate when the repair requires special tools or calibration.
Companion parts
- Inspect nearby fasteners, connectors, seals, fluids, and wear items before starting the repair.
- Use the service procedure and the visible package contents to identify any additional parts or tools required.
Before you buy
- Compare the listing title, photos, package contents, and specifications with the part being replaced.
- Confirm vehicle compatibility and installation requirements before ordering.
Customer feedback
Ratings and written reviews
4.0 / 5
38 source ratings
Source: Amazon. Imported marketplace feedback is shown for product research and is not a review of a purchase made on this website.
Garry Buckminster –
It worked great .
Dan l. –
Reamer is way to big the bushings fall out. Bushings themselves are also to big i.d. for shafts to fit and seal. I glued the bushings in with gas tank repair and aluminum dust mixed together and peened them in place it works good now. I’d use a drill next time and buy bushings that fit.
Grant Y. –
While the reamer works fine, the bushings supplied with it are not the correct ones. I had to purchase oilite bushings to use because the ones that cam with it are too thin and are loose in the hole.
MD –
Almost useless when the initial cutting edge on the reamer was nicked and dull. I did what I could to sharpen and managed to cut/hone one base plate, but I would not use it on another base plate. One star because the bushing were ok.
Jake Blues –
Actually the OD is just a smidge over 0.430 so maybe the bushing are closer to 10.93mm.Still, they are NOT 11mm OD and they do not have a press fit after using the supplied ream. What I will end up doing is not reaming all the way in so these bushing will not touch the butterflies and JB Weld to hold them in.I.D. compared to my throttle shaft is about 0.004 difference. Other bushings or shafts may vary.
cindy bellerose –
Works great
LP –
Reamer cut alright for a moment then quit cutting. I’m not sure if that became clogged with aluminum or what, but just like many others state the bushing dont fit the hole you just made. They fall out. Not only are they too thin a wall on the bushing, they are too big ID. Almost as sloppy as it was before I installed. Dont waist your money. Just go buy a new carburetor and save a headache.
Michelle Timmers –
Fixed a quadrajet with this