Description
Review this item in the context of the repair, installation access, nearby parts, and the result the completed job is intended to achieve.
Vehicle information
Available fitment details
Listing compatibility notes
- 【Adjustable Height】: Featuring an adjustable height from 19-1/2" - 33-1/4", the snowmobile jack is compatible with most snowmobile styles and can be used on either rear or front bumpers up to 1-3/5" thick.
Fitment data is provided as a buying aid. Verify the listing against your vehicle and existing part before ordering.
Repair scenarios, installation, companion parts, and use outcomes
Buying guidance
Quick decision
Review this stands in the context of the repair and the surrounding components.
Repair scenario
- Identify the symptom and confirm that this is the component required by the repair.
- Inspect nearby connectors, fasteners, and mating surfaces before installation.
Installation notes
- Use the listing instructions when present and follow the vehicle service procedure.
- Professional installation may be appropriate when the repair requires special tools or calibration.
Companion parts
- Inspect nearby fasteners, connectors, seals, fluids, and wear items before starting the repair.
- Use the service procedure and the visible package contents to identify any additional parts or tools required.
Before you buy
- Compare the listing title, photos, package contents, and specifications with the part being replaced.
- Confirm vehicle compatibility and installation requirements before ordering.
Customer feedback
Ratings and written reviews
4.2 / 5
16 source ratings
Source: Amazon. Imported marketplace feedback is shown for product research and is not a review of a purchase made on this website.
Dr. D –
Assembly was easy and a couple wrenches are provided. Use a half inch socket if you want to speed things up a bit. Note that the instructions are different than the picture shown for the direction of the base. It really shouldn’t matter though.This stand has quick adjustability with no tools required for height change. Just use the pin in different holes for different heights. This can be used to lift the back or front end.This lift is also good for summer storage to take the pressure off the suspension or it can even be used to tilt the sled on its side and have it supported by the handlebar.
Customer –
Pretty nice. Works well. Assembly was a snap. My husband reversed the direction of the handle 180 degrees opposite from the way it showed in the assembly diagram and it seems to work better. It would be nice if it had lockable caster wheels at the base for optional portability. But otherwise, it works as intended and the build quality seems quite nice.
ihaveastory6132onutube –
This is so easy to assemble and use! A few bolts and your jacked! Pull a pin, adjust height, pull a pin, flip the lever, and your off the ground! I can get my track on my MXZ 583 about 2″ off the ground. Just enough room to get underneath. Its sturdy, no fear of tippin or collapsing. For the price it works very well, is lightweight, easy to thro in the bed of a pick up and roll on……
John M. –
Works great
Sandy –
This stand is poor quality. Very flimsy and f difficult to usr
ThatNWGuy –
This does not work well with newer mountain sleds due to the rear snow flap, it just bends it in half. Works OK on the front no issues there as long as your bumper is relatively straight.
243 –
Does not lift the newer mountain sleds with the higher travel suspensions or taller aftermarket bumpers.
Dee Johns –
The media could not be loaded.