Description
Review this item in the context of the repair, installation access, nearby parts, and the result the completed job is intended to achieve.
Kit includes:
- 1310 CV transfer case yoke
- Installation hardware
FITS:
- All 96 and newer XJ Cherokee’s and 95 and older XJ’s when using the seal flange (sold separately as an option above)
*231 transfer cases with the 3 hole mounting seal housing will need the seal flange sold as an option above. This is typically found on older 231 cases(generally pre-1996).
- ZJ and WJ Grand Cherokee 242 transfer cases
Verify your 242 case has the 27 spline output shaft. These applications will require a custom length driveshaft.
- ZJ and WJ Grand Cherokee 247/249 transfer cases
These applications use a case hardened output shaft in the transfer case. This can make it difficult to drill and tap successfully without the proper equipment. A custom length driveshaft will be required for this application as well.
- Fits vehicles that have the AX-5/AX-15 manual trans. A custom shaft could be necessary in these vehicles.
- Other Fitments: NP233C
IMPORTANT NOTES:
- Cutting, drilling, and tapping required. 3/8-16 hand tap, 1/4″ and 5/16″ drill bits required. The transfer case output shaft is case hardened, so be sure to cut off the entire pilot hole (or you will need a carbide drill bit).
- WHAT DRIVESHAFT TO USE: This kit is designed to use a factory front Cherokee driveshaft. A factory XJ front shaft can be found at your local salvage yard for as low as $15! Iron Rock Off Road also sells this kit with the option of adding a brand new custom heavy duty driveshaft. This option can be found in the drop down list at the top of this product page.
- XJ’s with over 6.5″ lift may require a custom driveshaft. To be certain, you must measure per the instructions.
- Not all XJ’s have the ability to utilize the front driveshaft in the rear.
Vehicle information
Available fitment details
Listing compatibility notes
- About this item ZJ and WJ Grand Cherokee 242 transfer cases ZJ and WJ Grand Cherokee 247/249 transfer cases Fits vehicles that have the AX-5/AX-15 manual trans.
- Kit includes: 1310 CV transfer case yoke Installation hardware FITS: All 96 and newer XJ Cherokee's and 95 and older XJ's when using the seal flange (sold separately as an option above) *231 transfer cases with the 3 hole mounting seal housing will need the seal flange sold as an option above.
- Fits vehicles that have the AX-5/AX-15 manual trans.
- Other Fitments: NP233C IMPORTANT NOTES: Cutting, drilling, and tapping required.
Fitment data is provided as a buying aid. Verify the listing against your vehicle and existing part before ordering.
Repair scenarios, installation, companion parts, and use outcomes
Buying guidance
Quick decision
Review this transfer case components in the context of the repair and the surrounding components.
Repair scenario
- Identify the symptom and confirm that this is the component required by the repair.
- Inspect nearby connectors, fasteners, and mating surfaces before installation.
Installation notes
- Use the listing instructions when present and follow the vehicle service procedure.
- Professional installation may be appropriate when the repair requires special tools or calibration.
Companion parts
- Inspect nearby fasteners, connectors, seals, fluids, and wear items before starting the repair.
- Use the service procedure and the visible package contents to identify any additional parts or tools required.
Before you buy
- Compare the listing title, photos, package contents, and specifications with the part being replaced.
- Confirm vehicle compatibility and installation requirements before ordering.
Customer feedback
Ratings and written reviews
5.0 / 5
1 source rating
Source: Amazon. Imported marketplace feedback is shown for product research and is not a review of a purchase made on this website.
cjennings –
Installed on a WJ with 242 transfer case. Went together super smooth with the right drill bits and tap. Definitely recommend!