Description
Review this item in the context of the repair, installation access, nearby parts, and the result the completed job is intended to achieve.
✔Item Length:1.9 Centimeters
✔Item Width:18 Centimeters
✔Material:High-grade steel
✔OE Part Number:29450
✔29450 truck anchor pin bushing driver set removes and installs truck and trailer 1-3/8″ anchor pin bushings and stuck anchor pins.
✔If the part is damaged,please reach out to us
No structured vehicle fitment data is available. Compare the listing with the vehicle and existing part before ordering.
Repair scenarios, installation, companion parts, and use outcomes
Buying guidance
Quick decision
Review this bushing tools in the context of the repair and the surrounding components.
Repair scenario
- Identify the symptom and confirm that this is the component required by the repair.
- Inspect nearby connectors, fasteners, and mating surfaces before installation.
Installation notes
- Use the listing instructions when present and follow the vehicle service procedure.
- Professional installation may be appropriate when the repair requires special tools or calibration.
Companion parts
- Inspect nearby fasteners, connectors, seals, fluids, and wear items before starting the repair.
- Use the service procedure and the visible package contents to identify any additional parts or tools required.
Before you buy
- Verify the referenced part number: 29450.
- Compare the listing title, photos, package contents, and specifications with the part being replaced.
- Confirm vehicle compatibility and installation requirements before ordering.
Customer feedback
Ratings and written reviews
4.9 / 5
8 source ratings
Source: Amazon. Imported marketplace feedback is shown for product research and is not a review of a purchase made on this website.
Jay Stone –
It is a nice unit. It works great. You can take off the bushing with one side of the end and put the bushing in with the other side. It works fast with the right air chisel. It clicks in so the end does stay attached. to the shaft. Work great comes in Handley.
Danny –
When changing brakes, a lot of heavy vehicle mechanics will leave the anchor bushings in place. I’m not a fan of leaving something to further seize and be someone else’s problem. The effectiveness of this tool will rely mainly on the type of pneumatic air hammer you’re using. With a quality hammer (and maybe some heat), you shouldn’t have any issues driving old bushings out. Your biggest drawback to using this is the crud that rains down from vibrating the chassis. It’s definitely a cheaper alternative to a specialty screw type press.
Jennifer –
Of course since ordered haven’t needed but great tool
Blix –
At first the tool was a tight fit with flipping the head, but it has broken in and works great. Being a diesel mechanic I didn’t realize these came in two sizes. Got the short one but can’t complain about it.