Description
Review this item in the context of the repair, installation access, nearby parts, and the result the completed job is intended to achieve.
This exhaust extension allows for safe venting of exhaust fumes from an unoccupied enclosed area. The buyer will receive: a custom low profile stainless steel exhaust stub, a high temperature flexible graphite gasket, a custom stub to 1-1/2” ID tubing adapter, longer replacement screws & hex wrench, the specified length of 1-1/2 I.D. flexible galvanized exhaust pipe, and the proper size U-bolt clamp. This design is compatible with the EU6500is & EU7000is inverter generators.
Vehicle information
Available fitment details
Listing compatibility notes
- This design is compatible with the EU6500is & EU7000is inverter generators.
Fitment data is provided as a buying aid. Verify the listing against your vehicle and existing part before ordering.
Repair scenarios, installation, companion parts, and use outcomes
Buying guidance
Quick decision
Review this extension pipes in the context of the repair and the surrounding components.
Repair scenario
- Identify the symptom and confirm that this is the component required by the repair.
- Inspect nearby connectors, fasteners, and mating surfaces before installation.
Installation notes
- Use the listing instructions when present and follow the vehicle service procedure.
- Professional installation may be appropriate when the repair requires special tools or calibration.
Companion parts
- Inspect nearby fasteners, connectors, seals, fluids, and wear items before starting the repair.
- Use the service procedure and the visible package contents to identify any additional parts or tools required.
Before you buy
- Compare the listing title, photos, package contents, and specifications with the part being replaced.
- Confirm vehicle compatibility and installation requirements before ordering.
Customer feedback
Ratings and written reviews
4.3 / 5
29 source ratings
Source: Amazon. Imported marketplace feedback is shown for product research and is not a review of a purchase made on this website.
BigMike –
Simple but great product. Wanted to be able to run my Honda EU700is inside garage in order to keep it safe from predators. Obviously needed to vent exhaust. A 2.5″ hole in garage wall (covered by plywood when not needed) and, bam, it’s good to go. The parts here are high quality. Took me 10 minutes to install. Leave off generator when not needed. Great product that saved me lots of fabrication.
Bill & Jane –
I thought it was a bit high priced, but it is exactly what we needed, included very good hardware and instructions.
cwkouns –
Flexible and easy to install. Worked great to route exhaust out of the generator shack.
davybabe –
Quality tupe,gets the job done
Michael –
Perfect fit as described. Great quality. Nice job.
Customer –
I needed this for Hurricane Ian. I had the generator in a shed with a fan, but the exhaust buildup in the shed was too much.The most difficult part of the installation was the removal of the Honda screws, wow, they were on tight.I had worried the tube would create a loud exhaust sound at the end, but it was surprisingly quiet.The threaded adapter was also a nice touch. When putting away the generator, I simply unscrewed the tube which was convenient for storage.The only problem I had was unpacking. The gasket broke when I was opening the plastic wrapper. Since I had the generator in a shed, some leakage was not a problem. But be careful opening up the parts.
Todd –
I am not sure if the 8′ is too much back pressure on my quiet Honda 7000 watt inverter generator.I used the 8′ to get it above face injury or burn height on the outside of my metal building, but there seems to be a lot of exhaust inside the building (window open) I am thinking of cutting it down to a couple of feet and cutting an additional hole in my new metal building and patching the old one. But it will be down at little people height.
Gualberto Rivera –
I like the product because it extends the vapors away and far from contamination !